Konstrukcija brvnare

Montenegro brvnare se rade kao slobodno stojeći statički stabilan objekat po sistemu montažnih objekata na unaprijed pripremljenu soklu. Elementi brvnara se unizuju sa ugaonim uklještenjem odnosno ukrštaju u formi ćerta. Elementi brvana se unizuju do odgovarajuće spratne visine (260 cm - visina stanovanja ili na visinu po želji kupca) nakon čega se postavlja međuspratna konstrukcija u formi nosivih greda. Grede se urezuju kao i brvna na mjestima veze u stranice brvana. Nakon toga se unizuju elementi brvana na spratu ili potkrovlju zavisno od namjene objekta i želje kupca. Na dobijenu visinu potkrovlja ili sprata postavlja se krovna konstrukcija u formi rogova. Preko rogova se ukiva stropna obloga-lamperija na koju se postavlja hidro izolacija u formi PVC folije, a preko nje u pravcu rogova letve 30 x 50 mm. Između letava se postavlja termoizo1acija (tervol ili presovani stiropor) te nakon svega se pokiva daska colarica. Preko daske colarice se postavlja krovni pokrivač bitumenska tegola, a u slučaju korišćenja limenih lisnatih krovnih pokrivača pokivaju se letve u horizontalnom pravcu na koje se prikiva limeni krovni pokrivač.

Log cabin construction

Montenegro log cabin are produced as freely standing, statically stabile objects, made by system of prefabricated buildings on previously prepared foundation log cabin elements are put in line with angle clamp, that is, they are being crossover in a form ,,certo''.Elements of log cabins are put in line until appropriate floor height (260 cm-height of housing,or to height depending on buyer's demands) after which mezzanine construction is set in a form of supporting boards. Boards and logs are cut on the places of connection, into sides of logs. After that they are put in line on the floor or on the attick depending on purpose of the object and buyer's request. On accomplished height of the attick or a floor, roof construction is put in a form of horns. Over horns, ceiling armature-match boarding, is being riveted, over which hydro isolation is placed in a form of PVC films and over that, in hors direction, laths 30x50mm.Between laths, thermo-isolation is put(tervol or pressed styrofoom)and after all of that, board called colarica is put. Over the board, roof covering, bituminous tegola is put, and in case of using brass laminated roof coverings, laths are being covered horizontally and on them brass roof covering is riveted.